Diagnosis Procedure

1. Ignition switch OFF.
2. Turn lighting switch OFF.
3. Disconnect IPDM E/R connector and front combination lamp RH connector.
4. Check continuity between IPDM E/R harness connector and ground.

   IPDM E/R		--	Continuity
   Connector	Terminal
   E44	62	Ground	No

Is the inspection result normal?

YES

GO TO 2.

NO

Repair or replace harness.

CONSULT

1. Connect IPDM E/R connector.
2. Ignition switch ON.
3. Select "HEADLAMP (LO)" in "Active Test" mode of "IPDM E/R".
4. With operating the test items, check the voltage between front combination lamp RH harness connector and ground.

   +		-	Test item		Voltage (Approx.)
   Front combination lamp RH
   Connector	Terminal
   E38	4	Ground	HEADLAMP (LO)	On	Battery voltage
   				Off	0 V

Is the inspection result normal?

YES

GO TO 3.

NO

Replace IPDM E/R. Refer to Removal and Installation .

Check the headlamp (LO) RH. Refer to Component Inspection .

Is the inspection result normal?

YES

Inspection End.

NO

Repair or replace the malfunctioning part.