Diagnosis Procedure

1. Ignition switch OFF.
2. Disconnect stop lamp switch connector.
3. Check continuity of stop lamp switch terminals.

   Stop lamp switch		Condition		Continuity
   Terminals
   1	2	Brake pedal	Depressed	Yes
   			Fully released	No

Is the inspection result normal?

YES

Inspection End.

NO

GO TO 2.

1. Adjust stop lamp switch installation. Refer to Adjustment .
2. Check continuity of stop lamp switch terminals.

   Stop lamp switch		Condition		Continuity
   Terminals
   1	2	Brake pedal	Depressed	Yes
   			Fully released	No

Is the inspection result normal?

YES

Inspection End.

NO

Replace stop lamp switch. Refer to Removal and Installation .