Diagnosis Procedure
- CHECK HEADLAMP (LO) LH OPERATION
CONSULT
- Ignition switch ON.
- Select "HEADLAMP (LO)" in "Active Test" mode of "IPDM E/R".
- With operating the test items, check that the headlamp (LO) LH is turned ON.
On
: Headlamp (LO) LH ON
Off
: Headlamp (LO) LH OFF
Is the inspection result normal?
YES
GO TO 2.
NO
Perform the headlamp (LO) LH circuit diagnosis. Refer to Diagnosis Procedure .
- CHECK HEADLAMP WARNING LH SIGNAL
+
-
(Approx.)
Front combination lamp LH
Connector
Terminal
E37
7
Ground
Battery voltage
Is the inspection result normal?
YES
Replace front combination lamp LH. Refer to Removal and Installation .
NO
GO TO 3.
- CHECK HEADLAMP WARNING LH SIGNAL CIRCUIT
- Ignition switch OFF.
- Disconnect IPDM E/R connector and front combination lamp LH connector.
- Check continuity between front combination lamp LH harness connector and IPDM E/R harness connector.
Front combination lamp LH
IPDM E/R
Continuity
Connector
Terminal
Connector
Terminal
E37
7
E48
53
Yes
- Check continuity between front combination lamp LH and ground.
Front combination lamp LH
--
Continuity
Connector
Terminal
E37
7
Ground
No
Is the inspection result normal?
YES
Replace IPDM E/R. Refer to Removal and Installation .
NO
Repair or replace harness.