Diagnosis Procedure
- CHECK HEADLAMP (LO) RH OPERATION
CONSULT
- Ignition switch ON.
- Select "HEADLAMP (LO)" in "Active Test" mode of "IPDM E/R".
- With operating the test items, check that the headlamp (LO) RH is turned ON.
On
: Headlamp (LO) RH ON
Off
: Headlamp (LO) RH OFF
Is the inspection result normal?
YES
GO TO 2.
NO
Perform the headlamp (LO) RH circuit diagnosis. Refer to Diagnosis Procedure .
- CHECK HEADLAMP WARNING RH SIGNAL
+
-
(Approx.)
Front combination lamp RH
Connector
Terminal
E38
7
Ground
Battery voltage
Is the inspection result normal?
YES
Replace front combination lamp RH. Refer to Removal and Installation .
NO
GO TO 3.
- CHECK HEADLAMP WARNING RH SIGNAL CIRCUIT
- Ignition switch OFF.
- Disconnect IPDM E/R connector and front combination lamp RH connector.
- Check continuity between front combination lamp RH harness connector and IPDM E/R harness connector.
Front combination lamp RH
IPDM E/R
Continuity
Connector
Terminal
Connector
Terminal
E38
7
E44
60
Yes
- Check continuity between front combination lamp RH and ground.
Front combination lamp RH
--
Continuity
Connector
Terminal
E38
7
Ground
No
Is the inspection result normal?
YES
Replace IPDM E/R. Refer to Removal and Installation .
NO
Repair or replace harness.