Diagnosis Procedure

CHECK PARKING LAMP POWER SUPPLY CIRCUIT (SHORT)

Ignition switch OFF.
Turn lighting switch OFF.
Disconnect IPDM E/R connector and front combination lamp connector.

Check continuity between IPDM E/R harness connector and ground.

IPDM E/R				--	Continuity
Connector			Terminal
RH	E44		61	Ground	No
LH	E48		56

Is the inspection result normal?

YES

GO TO 2.

NO

Repair or replace harness.

CHECK PARKING LAMP POWER SUPPLY

CONSULT

Connect IPDM E/R connector.
Ignition switch ON.
Select "PARKING LAMP" in "Active Test" mode of "IPDM E/R".

With operating the test items, check the voltage between front combination lamp harness connector and ground.

+				-	Test item		Voltage (Approx.)
Front combination lamp
Connector			Terminal
RH	E38		6	Ground	PARKING LAMP	On	Battery voltage
						Off	0 V
LH	E37					On	Battery voltage
						Off	0 V

Is the inspection result normal?

YES

GO TO 3.

NO

Replace IPDM E/R. Refer to Removal and Installation .

CHECK PARKING LAMP
Check the parking lamp. Refer to Component Inspection .

Is the inspection result normal?

YES

Inspection End.

NO

Repair or replace the malfunctioning part.