Diagnosis Procedure

1. Ignition switch OFF.
2. Turn lighting switch OFF.
3. Disconnect IPDM E/R connector and front combination lamp RH connector.
4. Check voltage between IPDM E/R harness connector and ground.

   IPDM E/R		-	Voltage (Approx.)
   Connector	Terminal
   E44	62	Ground	0 V

Is the inspection result normal?

YES

GO TO 2.

NO

Repair or replace harness.

CONSULT

1. Connect IPDM E/R connector.
2. Ignition switch ON.
3. Select "HEADLAMP (LO)" in "Active Test" mode of "IPDM E/R".
4. With operating the test items, check the voltage between front combination lamp RH harness connector and ground.

   +		-	Test item		Voltage (Approx.)
   Front combination lamp RH
   Connector	Terminal
   E38	4	Ground	HEADLAMP (LO)	On	Battery voltage
   				Off	0 V

Is the inspection result normal?

YES

GO TO 3.

NO

GO TO 4.

1. Ignition switch OFF.
2. Check continuity between front combination lamp RH harness connector and ground.

   Front combination lamp RH		--	Continuity
   Connector	Terminal
   E38	1	Ground	Yes

Is the inspection result normal?

YES

GO TO 5.

NO

Repair or replace harness.

1. Ignition switch OFF.
2. Disconnect IPDM E/R connector.
3. Check continuity between IPDM E/R harness connector and front combination lamp RH harness connector.

   IPDM E/R		Front combination lamp RH		Continuity
   Connector	Terminal	Connector	Terminal
   E44	62	E38	4	Yes

Is the inspection result normal?

YES

Replace IPDM E/R. Refer to Removal and Installation .

NO

Repair or replace harness.

Check the headlamp (LO) RH. Refer to Component Inspection .

Is the inspection result normal?

YES

Inspection End.

NO

Repair or replace the malfunctioning part.