Fuel Pressure Release
WARNING: This page is about a different variant/trim than selected.
WITH CONSULT
CONSULT
- Turn ignition switch ON.
- Perform "FUEL PRESSURE RELEASE" in "WORK SUPPORT" mode with CONSULT.
- Start engine.
- After engine stalls, crank it two or three times to release all fuel pressure.
- Turn ignition switch OFF.
WITHOUT CONSULT
CONSULT
- Remove fuel pump fuse in IPDM E/R.NOTE:
- For the fuse number, refer to Wiring Diagram .
- For the fuse arrangement, refer to IPDM E/R Terminal Arrangement .
- Start engine.
- After engine stalls, crank it two or three times to release all fuel pressure.
- Turn ignition switch OFF.
- Reinstall fuel pump fuse after servicing fuel system.