Front Carrier, Input Clutch, Rear Internal Gear: Assembly

WARNING: This page is about a different variant/trim than selected.

Install input clutch component part (drive plates, driven plates, retaining plate, and dish plate) to input clutch drum.

Courtesy of NISSAN NORTH AMERICA, INC.

CAUTION: Check order of plates.

Install snap ring to input clutch drum using a flat-bladed screwdriver.

Courtesy of NISSAN NORTH AMERICA, INC.
CAUTION:
- Be careful not to scratch input clutch drum and input clutch retaining plate.
- Be careful not to damage snap ring.
Install needle bearing to input clutch assembly.

Courtesy of NISSAN NORTH AMERICA, INC.

CAUTION: Check the direction of needle bearing. Refer to Location of Needle Bearings and Bearing Races .
Install O-ring and seal rings to input clutch assembly.

Courtesy of NISSAN NORTH AMERICA, INC.
Install snap ring to front carrier assembly.

Courtesy of NISSAN NORTH AMERICA, INC.

CAUTION: Be careful not to expand snap ring excessively.
Compress snap ring using flat-bladed screwdrivers (A).

Courtesy of NISSAN NORTH AMERICA, INC.
CAUTION:
- Be careful not to scratch rear internal gear.
- Be careful not to damage snap ring.
Install front carrier assembly and input clutch assembly to rear internal gear.
Install needle bearing to front carrier assembly.

Courtesy of NISSAN NORTH AMERICA, INC.

CAUTION: Check the direction of needle bearing. Refer to Location of Needle Bearings and Bearing Races .