Removal and Installation: Installation

WARNING: This page is about a different variant/trim than selected.

Installation is in the reverse order of removal.

CAUTION:

Be careful not to damage connector when installing any connector.
Do not reuse joint connector.
Apply ATF to O-ring of joint connector.
Do not reuse drain plug and drain plug gasket. In addition, install new drain plug and drain plug gasket after adjustment of A/T fluid filling.

Refer to the following when installing the control valve & TCM to transmission case.

CAUTION:

Make sure that input speed sensor securely installs input speed sensor holes (A).

Courtesy of NISSAN NORTH AMERICA, INC.

Hang down output speed sensor harness toward outside so as not to disturb installation of the control valve & TCM.
Adjust joint connector of the control valve & TCM to terminal hole of transmission case.

Assemble it so that manual valve (1) cutout is engaged with manual plate (2) projection.

Courtesy of NISSAN NORTH AMERICA, INC.

Install bolts and clip (1) to the control valve & TCM. Tighten bolt (E) to the specified torque before tightening the other than bolts.

Courtesy of NISSAN NORTH AMERICA, INC.

: Front

*: Reamer bolt

Refer to the following when installing oil pan to transmission case.

CAUTION:

Clean foreign materials (gear wear particles) from inside of the oil pan and on the magnet, and then assembly.
Completely remove all moisture, oil and old gasket, etc. from oil pan gasket surface of transmission case and oil pan.
Do not reuse oil pan gasket and oil pan bolts.
Install oil pan gasket in the direction to align hole position.

Tighten the oil pan bolts to the specified torque in the sequence as shown after temporarily tightening them.

Courtesy of NISSAN NORTH AMERICA, INC.

: Front