Component Inspection (Shift Lock Solenoid)
WARNING: This page is about a different variant/trim than selected.
- CHECK SHIFT LOCK SOLENOID
Apply voltage to terminals of shift lock solenoid and park position switch (shift selector) connector and check that shift lock solenoid is activated.
CAUTION:- Connect the fuse between the terminals when applying the voltage.
- Never cause shorting between terminals.
(+)
(-)
Condition
Status
A/T shift selector
Terminals
3
1
Apply 12 V between terminals 3 and 1 with the park position switch (shift selector) in "P" (park) position.
Shift lock solenoid operates.
Is the inspection result normal?
YES
Inspection End.
NO
Replace A/T shift selector. Refer to Removal and Installation .