LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission (DTC/Circuit Diagnosis) (Re7R01B)) >> DTC/Circuit Diagnosis >> DTC U1000: Can Comm Circuit >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. PRECONDITIONING 

    If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

    GO TO 2.

  2. CHECK DTC DETECTION 

    SYMBOL With CONSULT

    1. Start the engine.
    2. Run engine for at least 2 consecutive seconds at idle speed.
    3. Perform "Self Diagnostic Results" in "TRANSMISSION".

    Is "U1000" detected?

    YES

    Go to Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Intermittent Incident .

    NO

    Confirmation after repair: INSPECTION END

scientia non olet · About LEMON Manuals