DTC Detection Logic

WARNING: This page is about a different variant/trim than selected.

DTC	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
P2767	Input/Turbine speed sensor B (Input/Turbine speed sensor "B" Circuit No Signal)	Diagnosis condition	When all of the following conditions are satisfied: Selector lever: D or R Gear position: 1st, 2nd, 3rd, 4th, 5th, 6th or 7th At no gear change Idle switch signal: OFF (Engine is not idling)
		Signal	Input speed sensor signal
		Threshold	The revolution of input speed sensor 2: Less than 270 rpm
		Diagnosis delay time	Maintained for 5 seconds or more