DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Always drive vehicle at a safe speed.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
GO TO 2.
- CHECK DTC DETECTION
With CONSULT
- Start the engine.
- Select "SLCT LVR POSI", "GEAR", "VHCL/S SE-A/T", "CLSD THL POS" and "ENGINE SPEED" in "Data Monitor" in "TRANSMISSION".
- Drive vehicle and maintain the following conditions for 5 seconds or more.CAUTION: Keep the same gear position.NOTE: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test.
SLCT LVR POSI
: D, R
GEAR
: 1st, 2nd, 3rd, 4th, 5th, 6th or 7th
VHCL/S SE-A/T
: More than 40 km/h (25 MPH)
CLSD THL POS
: OFF
ENGINE SPEED
: More than 1, 500 rpm
- Perform "Self Diagnostic Results" in "TRANSMISSION".
With GST
Follow the procedure "With CONSULT".
Is "P2767" detected?
YES
Go to DTC Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO
Confirmation after repair: INSPECTION END