DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Always drive vehicle at a safe speed.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
GO TO 2.
- CHECK DTC DETECTION
With CONSULT
- Start the engine.
- Drive vehicle to warm the engine and ATF.
- Drive vehicle under the following coast condition.
Engine
: After warming up
Select lever
: "D" position
Vehicle speed
: Acceleration to deceleration
(To make the coasting.)
- Perform step 3 a few times with various speeds.
- Perform "Self Diagnostic Results" in "TRANSMISSION".
With GST
Follow the procedure "With CONSULT".
Is "P2758" detected?
YES
Go to DTC Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO
Confirmation after repair: INSPECTION END