DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Always drive vehicle at a safe speed.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
GO TO 2.
- CHECK DTC DETECTION
With CONSULT
- Start the engine.
- Select "MANU MODE SW", "GEAR" and "VEHICLE SPEED" in "Data Monitor" in "TRANSMISSION".
- Drive vehicle and maintain the following conditions for 30 seconds or more.NOTE: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test.
MANU MODE SW
: ON
GEAR
: 2nd
VEHICLE SPEED
: 40 km/h (25 MPH) or more
- Perform "Self Diagnostic Results" in "TRANSMISSION".
With GST
Follow the procedure "With CONSULT".
Is "P0740" detected?
YES
Go to Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO
Confirmation after repair: INSPECTION END