DTC Detection Logic
WARNING: This page is about a different variant/trim than selected.
This malfunction is detected when the A/T does not shift into 2GR position as instructed by TCM. This is not only caused by electrical malfunction (circuits open or shorted) but by mechanical malfunction such as control valve sticking, improper solenoid valve operation, intake air leak, etc.
|
DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition |
|
|
P0732 |
2GR INCORRECT RATIO (Gear 2 Incorrect Ratio) |
Diagnosis condition |
-- |
|
Signal |
-- |
||
|
Threshold |
The gear ratio is:
|
||
|
Diagnosis delay time |
-- |
||