DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Always drive vehicle at a safe speed.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
GO TO 2.
- CHECK DTC DETECTION
With CONSULT
- Turn ignition switch ON.
- Select "VHCL/S SE-A/T" in "Data Monitor" in "TRANSMISSION".
- Start the engine and maintain the following condition for 10 seconds or more.
VHCL/S SE-A/T
: 10 km/h (7 MPH) or more
With GST
Follow the procedure "With CONSULT".
Is "P0713" detected?
YES
Go to DTC Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO
Confirmation after repair: INSPECTION END