DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
GO TO 2.
- CHECK DTC DETECTION
With CONSULT
- Turn ignition switch ON and wait 1 seconds or more.
- Perform "Self Diagnostic Results" in "TRANSMISSION".
Is "P0605" detected?
YES
Go to DTC Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO
Confirmation after repair: INSPECTION END