LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System (5.6L) (3 Of 3)) >> Periodic Maintenance >> EVAP Leak Check >> Inspection >> With Consult

With Consult

WARNING: This page is about a different variant/trim than selected.
  1. To locate the EVAP leak, install EVAP service port adapter (commercial service tool) and pressure pump to EVAP service port.
    G04074498Courtesy of NISSAN NORTH AMERICA, INC.
  2. Turn ignition switch ON.
  3. Select the "EVAP SYSTEM CLOSE" of "WORK SUPPORT" mode with CONSULT.
  4. Touch "START". A bar graph (Pressure indicating display) will appear on the screen.
  5. Apply positive pressure to the EVAP system until the pressure indicator reaches the middle of the bar graph.
  6. Remove EVAP service port adapter (commercial service tool) and hose with pressure pump.
  7. Locate the leak using a leak detector (commercial service tool). Refer to System Description .
    G04080319Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals