DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK DTC PRIORITY
If DTC U1024 is displayed with DTC P0607, first perform the trouble diagnosis for DTC P0607.
Is applicable DTC detected?
YES
Perform the diagnosis of the applicable. Refer to DTC Description .
NO
GO TO 2.
- PRECONDITIONING
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is 10 V or more at idle.
GO TO 3.
- PERFORM DTC CONFIRMATION PROCEDURE
- Turn ignition switch ON and wait at least 3 seconds.
- Check DTC.
Is DTC detected?
YES
Go to Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO
Confirmation after repair: INSPECTION END