LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System (DTC/Circuit Diagnosis) (5.6L) (1 Of 6)) >> DTC/Circuit Diagnosis >> DTC P0108: Atmospheric Pressure Sensor >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Start engine and let it idle for 5 seconds.
    2. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES

    DTC Diagnosis Procedure 

    NO

    INSPECTION END

scientia non olet · About LEMON Manuals