DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.

CHECK DTC PRIORITY
If DTC P0090 is displayed with DTC P1197, first perform the trouble diagnosis for DTC P1197.

Is applicable DTC detected?

YES

Perform the diagnosis of the applicable. Refer to DTC Description .

NO

GO TO 2.
PRECONDITIONING
If DTC CONFIRMATION PROCEDURE has been previously conducted, always perform the following procedure before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
- Before performing the following procedure, confirm that battery voltage is 11 V or more at idle.
- Before performing the following procedure, check that the fuel tank is 1/8 full of fuel.
GO TO 3.

PERFORM DTC CONFIRMATION PROCEDURE-I

WITH CONSULT

Start engine.
Select "COOLAN TEMP/S" in "DATA MONITOR" mode of "ENGNE" using CONSULT.

Maintain the following condition for 5 seconds or more at idle.

COOLAN TEMP/S

: 70 deg.C (104 deg.F) or more

Check 1st trip DTC.

WITH GST

Follow the above steps for "WITH CONSULT".

Is 1st trip DTC detected?

YES

Proceed to Diagnosis Procedure .

NO

To check malfunction symptom before repair: Refer to Intermittent Incident .

NO

Confirmation after repair: INSPECTION END