DTC Confirmation Procedure

• If DTC P0014 or P0024 is displayed with DTC P0078, P0084, first perform the trouble diagnosis for DTC P0078, P0084.

• If DTC P0014 or P0024 is displayed with DTC P1078, P1084, first perform the trouble diagnosis for DTC P1078, P1084.

Is applicable DTC detected?

YES

Perform the diagnosis of the applicable. Refer to DTC Index .

NO

GO TO 2.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is between 10 V and 16 V at idle.

GO TO 3.

WITH CONSULT

1. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT.
2. Start engine and warm it up to the normal operating temperature.
3. Maintain the following conditions for at least 6 consecutive seconds.

   Hold the accelerator pedal as steady as possible.

   ENG SPEED	1, 200 - 2, 000 rpm (A constant rotation is maintained.)
   COOLAN TEMP/S	More than 60 deg.C (140 deg.F)
   Selector lever	P or N position

4. Let engine idle for 10 seconds.
5. Check 1st trip DTC.

WITH GST

Follow the procedure "With CONSULT" above.

Is 1st trip DTC detected?

YES

Proceed to DTC Diagnosis Procedure 

NO

GO TO 4.

WITH CONSULT

1. Select "DATA MONITOR" mode with CONSULT.
2. Maintain the following conditions for at least 20 consecutive seconds.

   ENG SPEED	1, 700 - 2, 950 rpm (A constant rotation is maintained.)
   COOLAN TEMP/S	More than 70 deg.C (158 deg.F)
   Selector lever	D position
   Driving location uphill	Driving vehicle uphill (Increased engine load will help maintain the driving conditions required for this test.)

   CAUTION: Always drive at a safe speed.
3. Check 1st trip DTC.

WITH GST

Follow the procedure "With CONSULT" above.

Is 1st trip DTC detected?

YES

Proceed to DTC Diagnosis Procedure 

NO

To check malfunction symptom before repair: Refer to Intermittent Incident .

NO

Confirmation after repair: INSPECTION END