DTC Logic: Fail-Safe
WARNING: This page is about a different variant/trim than selected.
Not applicable
- CHECK DTC PRIORITY
If DTC C053C is displayed with other DTC, first perform the confirmation procedure (trouble diagnosis) for other DTC.
Is applicable DTC detected?
YES
Perform diagnosis of applicable. Refer to DTC Index .
NO
GO TO 2.
- PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 9 V at idle.
GO TO 3.
- PERFORM DTC CONFIRMATION PROCEDURE
- Start the engine and let it idle for at least 5 seconds.
- Check DTC.
Is DTC detected?
YES
Refer to Diagnosis Procedure .
NO
To check malfunction symptom before repair: refer to Intermittent Incident .
NO
Confirmation after repair: INSPECTION END