Component Inspection (Fuel Injector)
WARNING: This page is about a different variant/trim than selected.
- CHECK FUEL INJECTOR
- Turn ignition switch OFF.
- Disconnect fuel injector harness connector.
- Check the resistance between fuel injector terminals as per the following.
Injector
Condition
Resistance
+
-
Terminal
1
2
Temperature
10 - 60 deg.C (50 - 140 deg.F)
1.44 - 1.73 Ohm
Is the inspection result normal?
YES
INSPECTION END
NO
Replace malfunctioning fuel injector. Refer to Removal and Installation .