Component Inspection (Fuel Injector Relay)
WARNING: This page is about a different variant/trim than selected.
- CHECK FUEL INJECTOR RELAY
- Turn ignition switch OFF.
- Remove fuel injector relay.
- Check the continuity between fuel injector relay terminals as per the following conditions.
+
-
Conditions
Continuity
Fuel injector relay
Terminal
3
5
12 V direct current supply between terminals 1 and 2
Existed
No current supply
Not existed
- Check the continuity between high pressure fuel pump and fuel injector relay terminals as per the following conditions.
+
-
Conditions
Continuity
High pressure fuel pump and Fuel injector relay
Terminal
6
7
12 V direct current supply between terminals 1 and 2
Existed
No current supply
Not existed
Is the inspection result normal?
YES
INSPECTION END
NO
Replace fuel injector relay.