Removal and Installation: Notes

WARNING: This page is about a different variant/trim than selected.

WARNING:

Situate the vehicle on a flat and solid surface.
Place chocks at the front and back of rear wheels.
For engines not equipped with engine slingers, attach proper slingers and bolts described in PARTS CATALOG.

CAUTION:

Always be careful to work safely, and avoid forceful or uninstructed operations.
Do not start working until exhaust system and engine coolant are cool enough.
If items or work required are not covered by the engine information, refer to the applicable sections.
Always use the support point specified for lifting.
Use either 2-pole lift type or separate type lift as much as possible. If board-on type is used for unavoidable reasons, support at rear axle jacking point with transmission jack or similar tool before starting work, in preparation for the backward shift of the center of gravity.
For supporting points for lifting and jacking point at rear axle, refer to 2-Pole Lift .

NOTE:

When removing components such as hoses, tube/lines, etc., cap or plug openings to prevent fluid from spilling.