When New Connecting Rod And Crankshaft Are Used
WARNING: This page is about a different variant/trim than selected.
- Apply connecting rod big end diameter grade stamped (D) on connecting rod side face to the row in the "CONNECTING ROD BEARING SELECTION TABLE".
(A)
: Sample codes
(B)
: Bearing stopper groove
(C)
: Small-end diameter grade
(E)
: Weight grade
(F)
: Cylinder No.
(G)
: Management code
(H)
: Front mark
- Apply crankshaft pin journal diameter grade stamped on crankshaft front side to the column in the "CONNECTING ROD BEARING SELECTION TABLE".
(A)
: Pin diameter grade No. 1
(B)
: Pin diameter grade No. 2
(C)
: Pin diameter grade No. 3
(D)
: Pin diameter grade No. 4
(E)
: Journal diameter grade No. 1
(F)
: Journal diameter grade No. 2
(G)
: Journal diameter grade No. 3
(H)
: Journal diameter grade No. 4
(I)
: Journal diameter grade No. 5
- Read the symbol at the cross point of selected row and column in the "CONNECTING ROD BEARING SELECTION TABLE".
- Apply the symbol obtained to the "CONNECTING ROD BEARING GRADE TABLE" to select connecting rod bearing.