Main Bearing Cap Bolt Outer Diameter
WARNING: This page is about a different variant/trim than selected.
- Measure the outer diameters (A), (B) at two positions as shown in the figure.
(C)
: 20 mm (0.79 in)
(D)
: 55 mm (2.17 in)
(E)
: 12 mm (0.47 in)
- If reduction appears in (A) range, regard it (B).
Limit [(B) - (A)]
: 0.15 mm (0.0059 in)
- If it exceeds the limit (large difference in dimensions), replace main bearing cap bolts with new one.