Removal and Installation: Installation
WARNING: This page is about a different variant/trim than selected.
- Install front oil seal on front cover.CAUTION: Do not reuse front oil seal.
: Engine inside
: Engine outside
- Apply new engine oil to both oil seal lip (A) and dust seal lip (B).
- Install it so that each seal lip is oriented as shown in the figure.CAUTION: Be careful not to scratch or make burrs on circumference of oil seal.
- Using a suitable drift, press-fit oil seal until it becomes flush with front cover end face.
- Check the garter spring is in position and seal lips are not inverted.
- Installation of the remaining components is in the reverse order of removal.