LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical (5.6L)) >> Removal And Installation >> Drive Plate >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install pilot converter to the crankshaft using suitable tool, if removed.
    G04073390Courtesy of NISSAN NORTH AMERICA, INC.
    • With a drift of the following outer diameter, press-fit as far as it will go.

      Pilot converter

      : Approx. 35 mm (1.38 in)
    • Press-fit pilot converter with its chamfering side facing crankshafts shown in the figure.
      GNSJPBIA0210Z-210Courtesy of NISSAN NORTH AMERICA, INC.

      SYMBOL

      : Crankshaft side
  2. Install drive plate in the reverse order of removal.
    • Install drive plate (4) and reinforcement plate (3) as shown in the figure.
      GNSJPBIA2275Z-275Courtesy of NISSAN NORTH AMERICA, INC.

      (2)

      : Pilot converter

      (A)

      : Rounded

      SYMBOL

      : Engine front
    • When installing drive plate to crankshaft (1), be sure to correctly align crankshaft side dowel pin and drive plate side dowel pin hole.
      CAUTION: If these are not aligned correctly, engine runs roughly and "MIL" illuminates.
    • Holding ring gear with Tool.

      Tool number

      : KV10120100 (J-47245)
    • Tighten the bolts crosswise over several times.
  3. Installation of the remaining components is in the reverse order of removal.
scientia non olet · About LEMON Manuals