Removal and Installation: Installation
WARNING: This page is about a different variant/trim than selected.
- Install oil filter (for VVEL ladder assembly) (1) in the direction shown in the figure, if removed.
- Check that the oil filter does not protrude from the upper surface of cylinder block (2) after installation.
- Install engine coolant temperature sensor 1 and tighten to the specified torque.
Engine coolant temperature sensor 1
: 24.5 N.m (2.5 kg-m, 18 ft-lb)
- Install new cylinder head gaskets.CAUTION: Do not reuse gaskets.
- Install cylinder head as per the following:CAUTION:
- If cylinder head bolts are re-used, check their outer diameters before installation. Refer to Inspection .
- Before installing cylinder head, inspect cylinder head distortion. Refer to Inspection .
- Tighten cylinder head bolts in the sequence shown to the specified torque.NOTE: Apply new engine oil to threads and seat surfaces of cylinder head bolts.
(A)
: Bank 2
(B)
: Bank 1
: Engine front
Step 1
: Tighten 40.0 N.m (4.1 kg-m, 30 ft-lb)
Step 2
: Tighten 75 deg.
Step 3
: Loosen 0 N.m (0 kg-m, 0 ft-lb)
Step 4
: Tighten 40.0 N.m (4.1 kg-m, 30 ft-lb)
Step 5
: Tighten 90 deg.
Step 6
: Tighten 90 deg.
CAUTION: Check the tightening angle using Tool (A). Do not make judgment by visual inspection. - Install valve lifter.
- Install it in the original position.
- Installation of the remaining components is in the reverse order of removal.