Parts Requiring Angle Tightening
WARNING: This page is about a different variant/trim than selected.
- Use angle wrench [SST: KV10112100 (BT8653-A)] for the final tightening of the following engine parts:
- Cylinder head bolts
- Main bearing cap bolts
- Main bearing cap sub bolts
- Connecting rod cap bolts
- Crankshaft pulley bolt (No angle wrench is required as the bolt flange is provided with notches for angle tightening)
|
Tool number |
: KV10112100 (BT8653-A) |
- Ensure thread and seat surfaces are clean and coated with engine oil.