LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Control System (DTC/Circuit Diagnosis) (5.6L) (3 Of 6)) >> DTC/Circuit Diagnosis >> DTC P0222: TP Sensor >> DTC Diagnosis Procedure

DTC Diagnosis Procedure

WARNING: This page is about a different variant/trim than selected.
  1. CHECK THROTTLE POSITION SENSOR 1 POWER SUPPLY CIRCUIT-I 
    1. Disconnect electric throttle control actuator harness connector.
    2. Turn ignition switch ON.
    3. Check the voltage between electric throttle control actuator harness connector and ground.

      Electric throttle control actuator

      Ground

      Voltage (V)

      Connector

      Terminal

      F50

      2

      Ground

      Approx. 5

    Is the inspection result normal?

    YES

    GO TO 2.

    NO

    Repair open circuit, short to ground or short to power in harness or connectors.

  2. CHECK THROTTLE POSITION SENSOR 1 GROUND CIRCUIT FOR OPEN AND SHORT 
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Check the continuity between electric throttle control actuator and ECM harness connector.

      Electric throttle control actuator

      ECM

      Continuity

      Connector

      Terminal

      Connector

      Terminal

      F50

      4

      F79

      85

      Existed
    4. Also check harness for short to ground and short to power.

    Is the inspection result normal?

    YES

    GO TO 3.

    NO

    Repair open circuit, short to ground or short to power in harness or connectors.

  3. CHECK THROTTLE POSITION SENSOR 1 INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT 
    1. Check the continuity between electric throttle control actuator and ECM harness connector.

      Electric throttle control actuator

      ECM

      Continuity

      Connector

      Terminal

      Connector

      Terminal

      F50

      1

      F79

      78

      Existed
    2. Also check harness for short to ground and short to power.

    Is the inspection result normal?

    YES

    GO TO 4.

    NO

    Repair open circuit, short to ground or short to power in harness or connectors.

  4. CHECK THROTTLE POSITION SENSOR 

    Refer to Component Inspection (Throttle Position Sensor) .

    Is the inspection result normal?

    YES

    INSPECTION END

    NO

    GO TO 5.

  5. REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR 

    Replace electric throttle control actuator. Refer to Removal and Installation .

    INSPECTION END

scientia non olet · About LEMON Manuals