Component Inspection (Fuel Tank Temperature Sensor)

1. Turn ignition switch OFF.
2. Disconnect "fuel level sensor unit and fuel pump" harness connector.
3. Remove fuel level sensor unit.
4. Check resistance between "fuel level sensor unit and fuel pump " terminals by heating with hot water as shown in the figure.

   Courtesy of NISSAN NORTH AMERICA, INC.

   Terminals	Condition		Resistance (kOhm)
   4 and 6	Temperature [ deg.C (deg.F)]	20 (68)	2.3 - 2.7
   		50 (122)	0.79 - 0.90

Is the inspection result normal?

YES

INSPECTION END

NO

Replace "fuel level sensor unit and fuel pump".