LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Control System (DTC/Circuit Diagnosis) (5.6L) (4 Of 6)) >> DTC/Circuit Diagnosis >> DTC P100B: VVEL System >> Component Inspection (VVEL ACTUATOR MOTOR)

Component Inspection (VVEL ACTUATOR MOTOR)

WARNING: This page is about a different variant/trim than selected.
  1. CHECK VVEL ACTUATOR MOTOR 
    1. Turn ignition switch OFF.
    2. Disconnect VVEL actuator motor harness connector.
    3. Check resistance between VVEL actuator motor terminals as per the following.

      VVEL actuator motor

      Resistance

      Terminal

      1 and 2

      16 Ohm or less

    Is the inspection result normal?

    YES

    INSPECTION END

    NO

    GO TO 2.

  2. REPLACE VVEL ACTUATOR MOTOR ASSEMBLY 

    Replace VVEL actuator motor assembly. Refer to Removal and Installation .

    INSPECTION END