Component Inspection (VVEL ACTUATOR MOTOR)
WARNING: This page is about a different variant/trim than selected.
- CHECK VVEL ACTUATOR MOTOR
- Turn ignition switch OFF.
- Disconnect VVEL actuator motor harness connector.
- Check resistance between VVEL actuator motor terminals as per the following.
VVEL actuator motor
Resistance
Terminal
1 and 2
16 Ohm or less
Is the inspection result normal?
YES
INSPECTION END
NO
GO TO 2.
- REPLACE VVEL ACTUATOR MOTOR ASSEMBLY
Replace VVEL actuator motor assembly. Refer to Removal and Installation .
INSPECTION END