DTC Detection Logic
WARNING: This page is about a different variant/trim than selected.
When the selector lever position is P or N, park/neutral position (PNP) signal is sent to ECM from TCM.
|
DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition |
|
|
P0850 |
P-N POS SW/CIRCUIT (Park/neutral position switch) |
Diagnosis condition |
-- |
|
Signal (terminal) |
-- |
||
|
Threshold |
The signal of the park/neutral position (PNP) signal does not change during driving after the engine is started. |
||
|
Diagnosis delay time |
-- |
||