LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Control System (DTC/Circuit Diagnosis) (5.6L) (4 Of 6)) >> DTC/Circuit Diagnosis >> DTC P062F: Control Module >> DTC Diagnosis Procedure

DTC Diagnosis Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSPECTION START 
    1. Turn ignition switch ON and wait at least 1 second.
    2. Turn ignition switch OFF and wait at least 10 seconds.
    3. Repeat step 1 and 2 for 10 times.
    4. Erase DTC.
    5. Turn ignition switch OFF and wait at least 10 seconds.
    6. Turn ignition switch ON.
    7. Check the DTC.

    Is DTC erased?

    YES

    INSPECTION END

    NO

    GO TO 2.

  2. REPLACE ECM 
    1. Replace ECM. Refer to Removal and Installation .
    2. Perform Description .

    INSPECTION END

scientia non olet · About LEMON Manuals