DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
- PRECONDITIONING
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
GO TO 2.
- PERFORM DTC CONFIRMATION PROCEDURE
- Start the engine and let it idle for at least 5 seconds.
- Check 1st trip DTC.
Is 1st trip DTC detected?
YES
Go to Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO
Confirmation after repair: INSPECTION END