DTC Confirmation Procedure

• If DTC P0500 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX.
• If DTC P0500 is displayed with DTC P0607, first perform the trouble diagnosis for DTC P0607.

Is applicable DTC detected?

YES

Perform diagnosis of applicable. Refer to DTC Index .

NO

GO TO 2.

If DTC CONFIRMATION PROCEDURE has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is 10 V or more at idle.

GO TO 3.

1. Start engine.
2. Shift the selector lever to D range and wait at least for 2 seconds.
3. Drive the vehicle at least 5 seconds at 20 km/h (13 MPH) or more.
   CAUTION: Always drive vehicle at a safe speed.
   NOTE: This procedure may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle.
4. Check 1st trip DTC.

Is 1st trip DTC detected?

YES

Proceed to Diagnosis Procedure .

NO

To check malfunction symptom before repair: Refer to Intermittent Incident .

NO

Confirmation after repair: INSPECTION END