DTC Diagnosis Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK EVAP CONTROL SYSTEM PRESSURE SENSOR CONNECTOR
- Disconnect EVAP control system pressure sensor harness connector.
- Check that water is not inside connectors.
Is the inspection result normal?
YES
GO TO 2.
NO
Repair or replace harness connector.
- CHECK EVAP CONTROL SYSTEM PRESSURE SENSOR POWER SUPPLY CIRCUIT
- Turn ignition switch ON.
- Check the voltage between EVAP control system pressure sensor harness connector and ground.
EVAP control system pressure sensor
Ground
Voltage (V)
Connector
Terminal
C32
3
Ground
Approx. 5 V
Is the inspection result normal?
YES
GO TO 4.
NO
GO TO 3.
- CHECK SENSOR POWER SUPPLY 3 CIRCUIT
Perform DTC Diagnosis Procedure .
Is the inspection result normal?
YES
Perform the trouble diagnosis for power supply circuit. Refer to DTC Diagnosis Procedure .
NO
Repair or replace error-detected parts.
- CHECK EVAP CONTROL SYSTEM PRESSURE SENSOR
Refer to Component Inspection (EVAP Control System Pressure Sensor) .
Is the inspection result normal?
YES
INSPECTION END
NO
Replace EVAP control system pressure sensor.