Component Function Check

WARNING: This page is about a different variant/trim than selected.

PERFORM COMPONENT FUNCTION CHECK

WITH GST

Start engine and warm it up to the normal operating temperature.
Turn ignition switch OFF and wait at least 10 seconds.
Start engine and keep the engine speed between 3, 500 and 4, 000 rpm for at least 1 minute under no load.
Let engine idle for 1 minute.
Open engine hood.

Check the voltage between ECM harness connector terminals under the following conditions.

DTC	ECM				Condition	Voltage
	+		-
	Connector	Terminal	Connector	Terminal
P0420	F79	84 [HO2S2 (bank 1)]	F78	43	Keeping engine speed at 2, 500 rpm constant under no load	The voltage fluctuation cycle takes more than 5 seconds. 1 cycle: 0.6 - 1.0 -> 0 - 0.3 -> 0.6 - 1.0
P0430		77 [HO2S2 (bank 2)]

Is the inspection result normal?

YES

INSPECTION END