DTC Detection Logic

WARNING: This page is about a different variant/trim than selected.

Sensor

Input signal to ECM

ECM function

Actuator

A/F sensor 1

Density of oxygen in exhaust gas

(Mixture ratio feedback signal)

Fuel injection control

Fuel injector

DTC	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
P0335	CKP SEN/CIRCUIT (Crankshaft position sensor "A" circuit)	1	Diagnosis condition	Start engine and let it idle
			Signal (terminal)	Crankshaft position sensor signal
			Threshold	The crankshaft position sensor signal is not detected by the ECM during the first few seconds of engine cranking
			Diagnosis delay time	--
		2	Diagnosis condition	Start engine and let it idle
			Signal (terminal)	Crankshaft position sensor signal
			Threshold	The proper pulse signal from the crankshaft position sensor is not sent to ECM while the engine is running
			Diagnosis delay time	--
		3	Diagnosis condition	Start engine and let it idle
			Signal (terminal)	Crankshaft position sensor signal
			Threshold	The crankshaft position sensor signal is not in the normal pattern during engine running
			Diagnosis delay time	--