LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Control System (DTC/Circuit Diagnosis) (5.6L) (4 Of 6)) >> DTC/Circuit Diagnosis >> DTC P0335: CKP Sensor >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. CHECK DTC PRIORITY 

    If DTC P0335 is displayed with DTC P0643, first perform the confirmation procedure for DTC P0643.

    Is applicable DTC detected?

    YES

    Perform diagnosis of applicable. Refer to DTC Description .

    NO

    GO TO 2.

  2. PRECONDITIONING 
    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    TESTING CONDITION:

    Before performing the following procedure, confirm that battery voltage is 10.5 V or more with ignition switch ON.

    GO TO 3.

  3. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Start engine and let it idle for at least 5 seconds.

      If engine does not start, crank engine for at least 2 seconds.

    2. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES

    Go to Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Intermittent Incident .

    NO

    Confirmation after repair: INSPECTION END

scientia non olet · About LEMON Manuals