DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
- PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
GO TO 2.
- PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION A AND B
- Turn ignition switch ON and wait at least 1 second.
- Selector lever position is D and wait at least 3 seconds.
- Selector lever position is P.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON and wait at least 1 second.
- Selector lever position is D and wait at least 3 seconds.
- Selector lever position is P.
- Turn ignition switch OFF, wait at least 10 seconds, and then turn ON.
- Check DTC.
Is DTC detected?
YES
Go to Diagnosis Procedure .
NO
GO TO 3.
- PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION C
- Turn ignition switch ON and wait at least 1 second.
- Selector lever position is D and wait at least 3 seconds.
- Selector lever position is N or P.
- Start engine and let it idle for 3 seconds.
- Check DTC.
Is DTC detected?
YES
Proceed to Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO
Confirmation after repair: INSPECTION END