LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Control System (DTC/Circuit Diagnosis) (5.6L) (5 Of 6)) >> DTC/Circuit Diagnosis >> DTC P2118: Throttle Control Motor >> Component Inspection (Electric Throttle Control Motor)

Component Inspection (Electric Throttle Control Motor)

WARNING: This page is about a different variant/trim than selected.
  1. CHECK THROTTLE CONTROL MOTOR 
    1. Turn ignition switch OFF.
    2. Disconnect electric throttle control actuator harness connector.
    3. Check resistance between electric throttle control actuator terminals as per the following.

      Terminals

      Resistance

      5 and 6

      Approx. 1 - 15 Ohm [at 25 deg.C (77 deg.F)]

    Is the inspection result normal?

    YES

    INSPECTION END

    NO

    GO TO 2.

  2. REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR 

    Replace electric throttle control actuator. Refer to Removal and Installation .

    INSPECTION END