Component Inspection (Brake Pedal Position Switch)
WARNING: This page is about a different variant/trim than selected.
- CHECK BRAKE PEDAL POSITION SWITCH-I
- Turn ignition switch OFF.
- Disconnect brake pedal position switch harness connector.
- Check the continuity between brake pedal position switch terminals under the following conditions.
Terminals
Condition
Continuity
1 and 2
Brake pedal
Fully released
Existed
Slightly depressed
Not existed
Is the inspection result normal?
YES
INSPECTION END
NO
GO TO 2.
- CHECK BRAKE PEDAL POSITION SWITCH-II
- Adjust brake pedal position switch installation. Refer to Inspection and Adjustment .
- Check the continuity between brake pedal position switch terminals under the following conditions.
Terminals
Condition
Continuity
1 and 2
Brake pedal
Fully released
Existed
Slightly depressed
Not existed
Is the inspection result normal?
YES
INSPECTION END
NO
Replace brake pedal position switch. Refer to Removal and Installation .