Component Inspection (ASCD Steering Switch)
WARNING: This page is about a different variant/trim than selected.
- CHECK ASCD STEERING SWITCH
- Turn ignition switch OFF.
- Disconnect combination switch (spiral cable) harness connector M102.
- Check resistance between combination switch harness connector terminals under the following conditions.
Combination switch
Condition
Resistance (Ohm)
Connector
Terminals
M102
1 and 4
MAIN switch: Pressed
Approx. 0
CANCEL switch: Pressed
Approx. 250
COAST/SET switch: Pressed
Approx. 660
ACCELERATE/RESUME switch: Pressed
Approx. 1, 480
All ASCD steering switches: Released
Approx. 4, 000
Is the inspection result normal?
YES
INSPECTION END
NO
Replace ASCD steering switch.