DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK DTC PRIORITY
- If DTC P1212 is displayed with DTC UXXXX first perform the trouble diagnosis for DTC UXXXX.
- If DTC P1212 is displayed with DTC P0607 first perform the trouble diagnosis for DTC P0607.
Is applicable DTC detected?
YES
Perform diagnosis of applicable. Refer to DTC Index .
NO
GO TO 2.
- PRECONDITIONING
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is 10.5 V or more at idle.
GO TO 3.
- PERFORM DTC CONFIRMATION PROCEDURE
- Start engine and let it idle for at least 10 seconds.
- Check 1st trip DTC.
Is 1st trip DTC detected?
YES
Proceed to Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO
Confirmation after repair: INSPECTION END